Black Bear Gear Releases New Warrior Assault Plate Carrier.

Posted by Joshua Witteveen on

Black Bear Gear an Ontario based company has released the new Warrior Assault Systems Low Profile Carrier V1 which comes with Solid Side Cummerbunds. There also is a V2 that comes with ladder sides. With both versions it gives the wearer optimal carrier setup room. With the ability to add Warrior Assault Pouches or any other Molle capable pouch on the abundance of Molle room you can set this carrier up for any operational situation.
The Patent Pending Warrior LPC Low Profile Plate Carrier represents a new generation of armour carriers. Designed with direct input from serving operators within the SF community, the LPC incorporates many new features that combine to make it one of the best carriers on the market today. With certified Crye Multicam and Murdoc Webbing this carrier stands above the rest 
The LPC features our new air vent thermo pads, which allows heat to evaporate from the body and increase the airflow to assist in cooling. The Thermo Pad also helps to decrease the back plate signature associated with ballistic trauma. The LPC incorporates our speed clip system, which allows very rapid removal of the carrier on a day to day basis, but also in an emergency situation, no complicated cables to worry about, and reassembly takes seconds.
The LPC utilises state of the art materials to reduce the overall signature and weight. It comes as standard with a removable MOLLE front flap held in place by 2 vertical QASM clips and hook and loop which allows the panel to be removed and replaced with a wide variety of preconfigured panels that are both weapon and mission specific.
The carrier holds 10" x 12" ICW and stand alone plates front and back, and up to 6" x 8" side plates and soft armour.
Warrior has planned the release of two new colours (Black, Tan) coming the summer of 2020. Check out Black Bear Gear at to purchase the newest Warrior Assault Systems carrier on the market.

Share this post

Newer Post →

Leave a comment

Please note, comments must be approved before they are published.